1. To begin assembling the appliance, start by removing the cap from the cartridge.
2. Turn the flame control knob fully to the closed “right” (clockwise) position.
3. Align the cartridge collar notch with the locating pin on the torch and press down firmly while keeping the cartridge upright.
4. Rotate the torch body clockwise until it stops.
5. Remember to only use cartridges equipped with a bayonet fitting for proper assembly.

For ignition and operation:

1. Slowly turn the flame control knob to the “left” (anti-clockwise) high position to initiate gas flow.
2. Pull the auto ignition trigger located at the centre of the torch until it clicks to start the flame.
3. Repeat this step until the torch ignites.
4. Adjust the flame intensity by turning the control knob between the “right” (low) and “left” (high) positions as required.
5. During the initial 20-second warm-up period, ensure the appliance remains upright to prevent flaring.
6. To shut off the torch, securely close the gas supply by turning the flame control knob fully to the “right” (clockwise) low position and hand tighten.
   

After using the appliance:

1. Allow it to cool before separating it from the gas cartridge.
2. Ensure the appliance is clean and dry before storage.
3. Once the cartridge is separated and the cap replaced, store the appliance in a cool, well-ventilated location.